Enviro Series D - Telescoping Bottom Panel Installation

ENVIRO-TEC
8
FORM ET115.24-NOM11 (118)
Any devices such as fan switches or thermostats
that have been furnished from the factory for eld
installation must be wired in strict accordance with the
applicable wiring diagrams. Failure to do so could result
in personal injury or damage to components and will
void all manufacturers’ warranties.
All eld wiring should be done in accordance with
governing codes and ordinances. Any modication of
the unit wiring without factory authorization will result
in voiding of all factory warranties and will nullify any
agency listings.
The manufacturer assumes no responsibility for any
damages and/or injuries resulting from improperly eld
installed or wired components.
This unit is listed to UL/CSAS standards. All
modications to line voltage wiring must be performed
in accordance with the NEC and inspected by ETL to
maintain product listing. Unauthorized modication to
any wiring may impact unit performance and void ETL
listing and/or product warranty.
TELESCOPING BOTTOM PANEL
The telescoping bottom panel allows for fully recessing
the unit while permitting service access into the ceiling
plenum. The architectural ceiling panel is nished with
a durable powder coat paint.
Portions of the inlet louver not directly
below unit inlet may require covering
in the field on applications where
inltration of ceiling plenum air into
space is undesired. Telescoping skirt
and collar assembly must be field
adjusted to assure a proper t between
lter frame and louvered inlet panel
assembly. Refer to assembly submittal
drawings for specic dimensions.