ENVO D50 | ST50 EBIKE MANUAL | VERSION 1.0 21
4. ASSEMBLY INSTRUCTIONS
4.1. GENERAL REQUIREMENTS
Products listed in your order need to be installed professionally, as they require ne-tuning and
adjustment after installation. It is highly recommended to get help from an experienced mechanic,
refer to your local dealers, or book an appointment with us for an Installation session. If you
choose to do it yourself, with your own responsibility, please make sure you refer to our available
online guides as this is a safety concern.
Some Bicycle accessories may present a choking hazard and other hazards to small children.
Keep any bike parts accessories, tools away from small children.
4.2. UNBOXING
• Open the box from the top side
• Please be careful when pulling the frame out, it is the heaviest part of the bike, and the handlebar
is attached. You must be careful to protect the cables from getting tangled
• Two people are recommended for the unboxing procedure
4.3.UNPACKING
• Cut all the zip ties and separate the wheel
• Do not damage the battery as it is mounted on the bike frame
• Remove all packaging wrap
While cutting zip ties be careful not to scratch or damage your bike, be extra cautious while
cutting zip ties around wire connections and cable housings. Do not damage the battery
when removing it the frame from the box.
4.4. TOOLS REQUIRED
• Allen key set (4mm, 5mm, 6mm), Wrench (8mm, 15mm), Grease
To Next Page
Loading...
