ENVO D50 | ST50 EBIKE MANUAL | VERSION 1.0 40
6.4. RECOMMENDED SERVICE INTERVALS
It is important to inspect and service the electric bike to maintain optimal performance. The
recommended service is only a guideline, every bike is used differently, and its wear and tear are
accordingly.
INTERVAL INSPECT/SERVICE
Every Week • Check bolts and fasteners for proper torque value
• Check chain, freewheel, and derailleur for proper alignment
• Check if wheels are true
• Check frame for any scratch or damage
• Clean frame by wiping with a damp cloth
• Use barrel adjuster to tension brakes and derailleur if needed
Every Month • Check brake pad alignment
• Check if gears are shifting properly
• Check brake and gear cables for rust
• Check spoke tension
• Lubricate drivetrain
• Check torque values of pedal and crankset
• True the wheels
• Check bearing adjustment
• Check rim for wear
• Lubricate forks
Every 6 Month • Inspect chain, freewheel, and derailleur
• Lubricate handlebar stem
• Lubricate seat post
• Grease bearings
• Replace brake pads
• Replace tires if necessary
• Replace cables if necessary
• If you see a crack in any part of the bike, replace that part immediately as a crack and grow
without any warning and may break the part during operation
• If you see any rust on the ebike, make sure to clean the bike and lubricate it properly. If the rust
is excessive, replace the part
• Make sure to avoid scratching or gouging any surface as these are stress concentration points
that could lead to crack formation
• If there is any noise coming from the ebike, investigate its cause and make sure to rectify the
problem as soon as possible
To Next Page
Loading...
