EasyManua.ls Logo

ENVO D50 - Page 36

ENVO D50
47 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
ENVO D50 | ST50 EBIKE MANUAL | VERSION 1.0 36
8. If the rear derailleur or the dropout/derailleur hanger is bent, the rear derailleur may collide
with the spokes. This can result in damage to the rear derailleur, the rear wheel and/or the
frame. Check the function of the front derailleur. A displaced front derailleur can throw off the
chain, which will suddenly interrupt the drive of the bike, potentially leading to an accident,
injury or death
9. Conrm the saddle is not out of alignment, using the top tube or the bottom bracket shell as a
reference
10. Let your bike bounce on the ground from a low height. If there is any rattling, see where it
comes from. Check the bearings, the bolts and the proper seating of the battery and the
connectors, as necessary
11. Check the display. Are all the values displayed as usual? Do not use your bike if the display
shows an error message or a warning. If necessary, switch off the system and wait at least 10
seconds before turning it on and checking it again
12. Take a good look at the whole bike to detect any deformation, colour changes, cracks. Ride
back very carefully or walk your bike back to a professional mechanic and have the mechanic
check the bike and help resolve any issues
13. If you have had an accident and are unsure whether your bike will function properly, leave your
bike rather than risk riding and endangering yourself and others
14. If you do ride your bike, do not accelerate or brake hard until the bike has been checked by a
bike mechanic
15. Deformed components, especially those made of aluminum, can break without previous
warning. If this occurs, they may not be repaired, i.e. straightened, as the imminent risk of
breakage will remain. This applies in particular to the fork, the handlebars, the stem, the cranks,
the seat posts and the pedals. When in doubt, you should replace these components
16. At no time should you make any modications to your ebikes electrical systems, unless they are
explicitly approved by the manufacturer in writing
17. Contact your dealer or ENVO support for repairs and replacement parts in case of damage
Do not set off on your bike with drive assistance if the control element shows a warning.
Doing so could lead to serious injury or death.

Related product manuals