ENVO E50 | E35 SCOOTER MANUAL | VERSION 1.0
18
4. ASSEMBLY INSTRUCTIONS
4.1. GENERAL REQUIREMENTS
The ENVO electric scooters come 95% pre-assembled, the assembly process is straightforward
but if you feel uncomfortable putting the product together we highly suggest you get help from
a professional or a mechanically inclined person. If you choose to do it yourself, with your own
responsibility, please make sure you refer to following guidelines along with resources available on
ENVO’s website.
Some accessories may present a choking hazard and other hazards to small children. Keep
any small parts and/or tools away from small children.
4.2. UNBOXING
• Open the box from the top side
• Please be careful when pulling the scooter out. You must be careful to protect the cables from
getting tangled
• Two people are recommended for the unboxing procedure
4.3.UNPACKING
• Cut all the zip ties or tape
• Remove all packaging wrap
While cutting zip ties/tape be careful not to scratch or damage your bike, be extra cautious
while cutting zip ties around wire connections and cable housings.
4.4. TOOLS REQUIRED
• Allen key set (2.5mm)
To Next Page
Loading...
