ENVO E50 | E35 SCOOTER MANUAL | VERSION 1.0
20
Figure 4C Figure 4D
4.5.2. ENVO E35 ASSEMBLY
• Place the scooter on the ground by engaging the kickstand as shown in Figure 4C
• Connect the waterproof cable going from cockpit of the scooter into folding stem
• Insert the handlebar stem into the folding stem
• Lock the folding stem in place using the clamp, a “click” sound will let you know when the
clamp is engaged
• After the folding stem is secured, fasten the handlebar stem on to the folding stem using four
counter sink screws using 2.5mm allen key as shown in Figure 4B
• The brake cable may come unassembled, simply engage the wire barrel into the shifter and
tighten the wire using barrel adjuster.
Fasteners must be tightened correctly. Fasteners are not secured if the torque is too little,
and the fasteners can deform, stretch, or break if the torque is too much. Incorrect torque
can lead to component failure resulting in serious injury or even death.
To Next Page
Loading...
