EP Equipment EPL152 - Moving Truck Without Drive System; Manual Movement Procedure

REV. 03/2020
24B
2.3.11 Operating the truck without its own drive system
If the truck has to be moved after a failure
has rendered it immobile, proceed as
follows:
Set the emergency stop switch “OFF”.
Set the key switch “OFF” and remove the
key.
Prevent the truck from rolling away.
Remove the cover.
Screw in two screws(1), M4*35mm)until the
truck can be moved (no braking action).
After setting down the truck at the
destination, unscrew two screws(1)
.
Braking action is restored.
•
•
•
•
•
•
This operating mode is not permitted
when negotiating inclines and
gradients.
WARNING