5-1 Glue supply
Warning!
Do not touch the melt tank or the application roller. High temperature will cause
severe personal injury.
When the glue in the melt tank is not enough, please supply glue in time.
-Turn on the machine, make sure the glue is
fully melted in the melt tank.
-Turn off main power and wait 10 minutes/
-Open the melt tank cover with Handle
- Place the glue into the melt tank.
- Close the melt tank cover.
- Turn on the machine to heat the glue.
- Please do not supply too much glue. Please
check the glue level indicator.
- Please use the glue supplied by E-P
Equipment.
5. Maintenance
To Next Page