( 8 )
GB-6210 Manual
3-3. Knowledge of how to bind a good book
3-3-1 It is very important that the book stock should be trued up before binding. Good
and strong binding depends on spine-alignment of stock. To apply glue on spine
equally, all sheet must touch the level plate. Make sure the stock aligned enough.
3-3-2 The thickness (weight) of paper which can be used for cover is from 70-180
gsm. Do not use the cover too thin or too thick.
3-3-3 keep the clamper and the nipper clean. Otherwise the binding quality may be
affected by dusts or pieces of glue on the level plate and the nipper.
3-3-4 Do not open the bound book within five minutes.
3-3-5 Do not bind books which have been bound before or have glue on the book spine.
It may damage the Roughening cutter.
3-3-6 Please supply enough glue in the melt tank.
To Next Page
Loading...