EP Equipment PB2000 - Page 20

( 19 )
GB-6210 Manual
5-3-1 Turn on the machine
ON!
- Plug the power cord to outlet.
- Turn on the main switch.
- The Heat Preparation Lamp turns on, the
machine is heating the glue in the melt tank.
5-3-2 Melt glue
ON!
- Warming up time is about 20 minute.
- When Start lamp turns on, keep waiting 10
more minutes so that the glue in the melt tank
can fully melted.
5-3-3 Depress Reset Button
- Keep depressing Reset Button for about 5
seconds, the clamper will move forward and
stop at the front position above the nipper.
ON!
5-3-4 Remove the back cover
- Remove the back cover like above picture.
- Slowly get the back cover to the roller.