REV. 12/2020
17
B
Never transport a load with the forks in the
raised position as the equipment may become
unstable.
Always drive forwards for optimum visibility.
When carrying a load on a slope, always
climb and descend with the load up-hill.
Never travel diagonally across the slope or
make a U-turn.
Reverse gear must only be used for deposit-
ing a load.Since visibility in this direction is
restricted, you should only travel at very low
speed.
Never drive with an unstable load.
If visibility is poor, let someone guide you.
Be careful of low passageways, low door-
ways, scaolding, pipes etc.
To facilitate movement over obstacles,
increase the ground clearance.
Check that the width of the load is compatible
with the width of the aisle.
DANGER
DANGER
Personnel must not stand under or near the
mast when the load is in the raised position.
Carrying a load
Fig2108-00029OM
To Next Page
Loading...
