ep WPL201 - Operating the Truck Without Its Own Drive System

REV. 09/2020
B25
Incorrectuseofthetruckonslopesplacesstressonthetractionmotor,brakesandbattery.
i
NOTE
1.3 Operating the truck without its own drive system
If the truck has to be moved after a failure has
rendered it immobile, proceed as follows:
Set the emergency stop switch “OFF”.
Set the key switch “OFF” and remove the key.
Prevent the truck from rolling away.
Remove the cover.
Screw in two screws(1), M4*35mm)until the
truck can be moved (no braking action).
After setting down the truck at the destination,
unscrew two screws(1).
Braking action is restored.
•
•
•
•
This operating mode is not permitted
whennegotiatinginclinesandgradients.
WARNING
Afterpowero,brakeworksandthe
truckcannotbetowed(dragged).
WARNING