What to do if the Load LED indicator is fast flashing on my Epever LS1024E?
If the load LED indicator on your Epever Controller is flashing rapidly, it indicates a short circuit. The controller will automatically resume operation after 10 seconds following the first short circuit. If a second short circuit occurs, press the button to resume operation after 3 seconds.
Why is the charging LED indicator fast flashing on my Epever Controller?
If the charging LED indicator on your Epever Controller is flashing rapidly, it means the battery voltage is higher than the over voltage disconnect voltage (OVD). Check if the battery voltage is too high and disconnect the solar module.
What to do if the Load LED indicator is slowly flashing on my Epever LS1024E Controller?
If the load LED indicator on your Epever Controller is flashing slowly, it indicates an overload. Reduce the load and press the button once. The controller will resume working after 3 seconds.
How to fix a charging LED indicator that is off during daytime on my Epever LS1024E?
If the charging LED indicator is off on your Epever Controller during the daytime when sunshine falls on PV modules properly, it could be due to a PV array disconnection. Check if the PV and battery wire connections are correct and tight.
Why is there no charging status LED indicator with a normal connection on my Epever LS1024E Controller?
If there is no charging status LED indicator with a normal connection on your Epever Controller, the input voltage of the solar module may be lower than the battery voltage. Measure the input voltage of the solar module; it must be higher than the battery voltage.
What does it mean when the Battery LED1 indicator is slowly flashing on my Epever Controller?
If the battery LED1 indicator is flashing slowly on your Epever Controller, it indicates that the battery is under voltage. When the load output is normal, the LED status will return to ON automatically when fully charged.
What does it mean when the Battery LED1 indicator is fast flashing on my Epever LS1024E Controller?
If the battery LED1 indicator is flashing rapidly on your Epever Controller, it means the battery is over discharged. When the controller cuts off the output automatically, the LED status will return to ON automatically when fully charged.
Why is there no LED indicator on my Epever LS1024E?
If there is no LED indicator on your Epever Controller, it could be because the battery voltage is lower than 6V. Measure the battery voltage with a multi-meter. A minimum of 6V is required to start the controller.
Safety and procedural guidelines for physically installing the solar charge controller.
Instructions for connecting the solar charge controller to system components.
Overview of controller features and indicator lights, including system status.
Instructions for setting load work mode and battery type selection.
Details on protection mechanisms like load overload, short circuit, and reverse polarity.
Guidance for diagnosing and resolving common faults and issues based on LED indicators.
General| Rated Voltage | 12V/24V Auto |
|---|---|
| Rated Current | 10A |
| Rated Charge Current | 10A |
| Rated Load Current | 10A |
| Max. PV Input Power | 130W (12V) / 260W (24V) |
| Max PV Input Voltage | 50V |
| Max. PV open circuit voltage | 50V |
| Load Control | Yes |
| Temperature Compensation | -3mV/°C/2V (Default) |
| Display | LED |
| Self-consumption | <10mA |
| Operating Temperature | -35°C to +55°C |
| Battery Type | Gel |
| Protection | Overload, Short-circuit, Reverse polarity |
To Next Page
