What to do if Epever MPPT Tracer1206AN shows overload?
If your Epever Controller indicates an overload, reduce the number of connected electrical devices. Then, restart the controller or press the button to clear the fault.
What to do if Epever MPPT Tracer1206AN Controller has load short-circuit?
If the Epever Controller displays a load short-circuit, carefully check the load connections and clear the fault. Then, restart the controller or press the button to clear the faults.
What to do if Epever Controller indicates battery over discharged?
If your Epever Controller indicates that the battery is over discharged, the load will recover when the battery voltage is restored to or above the LVR (low voltage reconnect voltage). In the meantime, use alternative methods to recharge the battery.
How to fix PV array open-circuit on Epever MPPT Tracer1206AN?
To address a PV array open-circuit issue with your Epever Controller, verify that the PV array connections are correct and securely tightened.
Why Epever MPPT Tracer1206AN does not work when battery voltage is lower than 8V?
If the battery voltage is lower than 8V when using the Epever Controller, check the battery's voltage. It needs to have at least 8V to activate the controller.
General| Brand | Epever |
|---|---|
| Model | MPPT Tracer1206AN |
| Category | Controller |
| Language | English |
Adopts MPPT control algorithm for efficient energy harvesting and system stability.
Identifies and illustrates the controller's physical ports, buttons, and LCD display.
Explains the nomenclature used for different controller models and specifications.
Describes the MPPT technology for optimizing solar energy conversion.
Details the three-stage charging process: Bulk, Constant, and Float charging.
Key safety and environmental considerations before and during controller installation.
Specifies PV module compatibility and array configuration guidelines.
Provides recommended wire sizes for PV, battery, and load connections.
Step-by-step instructions for physically installing the solar controller.
Explains the purpose and usage of the controller's SELECT and ENTER buttons.
Describes status icons, error codes, and browsing through different interfaces.
Guides on configuring battery types, temperature units, and other operational settings.
Details how to configure load operation modes and timers.
Lists various protection mechanisms for the controller and battery system.
Provides solutions for common faults and operational issues.
Recommends regular inspections and maintenance for optimal performance.
Tabulated electrical characteristics of the controller models.
Physical dimensions, mounting details, and cable specifications.
To Next Page