Why is my Epever Tracer6415AN not working even though the wiring is correct?
If the wire connection is correct, but the Epever Controller is not working, the battery voltage may be lower than 8V. Please check the battery's voltage and ensure it is at least 8V to activate the controller.
What to do if Epever Tracer6415AN is used in area with lightning strikes?
If you plan to use the Epever Controller in an area prone to frequent lightning strikes, it's advisable to install an external surge arrester.
How to fix a charging LED that is OFF on my Epever Tracer6415AN Controller during the day?
If the charging LED is off during the daytime when sunshine falls on PV array properly, it may be due to a PV array open-circuit. Confirm whether the connection of the PV array is correct and tight.
How to prevent battery reverse polarity on Epever Tracer6415AN?
Do not connect the battery wires with reverse polarity, as this may damage the Epever Controller.
Explains the meaning of various safety warning symbols used in the manual.
Guidelines for selecting and connecting PV modules based on voltage and power.
Specifies appropriate wire gauges for PV input and battery connections.
Guide to configuring battery types, voltages, and other parameters.
Details the controller's protection features against various faults.
Provides solutions for common issues and recommendations for regular upkeep.
General| Model | Tracer6415AN |
|---|---|
| Type | MPPT Solar Charge Controller |
| Rated Charge Current | 60A |
| Rated Discharge Current | 60A |
| System Voltage | 12V/24V/36V/48V Auto |
| Max. PV Open Circuit Voltage | 150V |
| Efficiency | ≤98% |
| Altitude | ≤3000m |
| Discharge Circuit Voltage Drop | ≤0.15V |
| Battery Type | Gel, Lithium |
| Temperature Compensation | -3mV/°C/2V (Default) |
| Communication | RS485, USB |
| Grounding | Negative Ground |
| Protection | Overload, Short Circuit, Reverse Polarity |
| Cooling | Natural Cooling |
| Dimensions | 70mm |
| Operating Temperature | -25°C to +50°C |
To Next Page