24
CP4B Room Thermostat
Installer menu
To access the installer menu, you must hold Prog and OK for 5 seconds.
When in the installer menu, use the
, and
OK
to navigate and select.
Use
AUTO
,
MAN
or
OFF
to go back a step.
P0 1: Mode (Normal / Optimum Start / TPI)
P0 2: Hi Lo (Limiting the Thermostat)
P0 3: Hysteresis (Dierential)
P0 4: Calibration
P0 5: Frost Protection
P0 6: Exit
Installer menu OpenTherm® Instructions
(Only for use with OT boilers)
P0 6: Setting DHW Temperature
P0 7: OpenTherm® Information
P0 8: DHOP
P0 9: Set OpenTherm® Parameters
Exit
To Next Page
Loading...
