EPH Controls CP4M - Installer Menu Configuration

25
EPH Control Ltd.
Installer menu
To access the installer menu, you must hold
PROG
and
OK
for 5 seconds.
When in the installer menu, press
, and
OK
to navigate and select.
Use
AUTO
,
MAN
or
OFF
to go back a step.
P0 1: Mode (Normal / Optimum Start / TPI)
P0 2: Hi Lo (limiting the thermostat)
P0 3: Hysteresis (dierential)
P0 4: Calibration
P0 5: Frost Protection
PIN
Exit
Installer menu (with OpenTherm® connected)
P0 6: Setting DHW temperature
P0 7: OpenTherm® Information
P0 8: DHOP
P0 9: Set OpenTherm® Parameters
Exit