28
TEMPERATURE SETPOINT DISPLAY
When the HPAC 2.0 is turned on, the three digits on the display will show the
desired temperature.
It is possible to set the desired temperature between 61°F and 87°F in half degree
increments. The HPAC 2.0 will bring the room to the desired temperature.
NOTICE
If the temperature is set too low or too high, it can be unhealthy
and an unnecessary waste of energy.
POWER ON/OFF
Power the HPAC 2.0 on or off (standby) by pressing and holding the Power button
for 3 seconds. The control system of the HPAC 2.0 is equipped with a memory, so
settings will not be lost if the HPAC 2.0 is turned off or there is a loss of power.
The Power button is used to activate or deactivate the HPAC 2.0 for short time
periods only. In the case of long periods of inactivity, the HPAC 2.0 must be
unplugged from the power grounded three-prong electrical power outlet.
DEHUMIDIFICATION MODE
In dehumidification mode, the HPAC 2.0 dehumidifies the room.
To activate dehumidification mode, press and hold the mode button sequentially,
until the both the sun and snowfall are lit up.
This mode is useful during the spring and fall when the temperature is pleasant, but excess
humidity may cause discomfort. This mode ignores both room temperature and fan speed
settings. The fan operates only on low speed. It is normal for the HPAC 2.0 to work intermittently.
To Next Page
Loading...
Need help?
General