47
EMPTYING CONDENSATE TRAY
During cooling and dehumidifi cation, an electronic controller maintains the water distribution system by spraying the
condensate from collection pan onto the heat exchanger.
During heating, the unit does not drain the condensate directly into the drain pipe, but rather it collects into a lightly
heated collection pan (to eliminate icing up of the liquid) where a solenoid valve controls the fl ow of the condensate
from the internal collection tray to the drain pipe once the maximum level has been reached.
Should any issue occur in the condensate water system or if the maximum level of water in the pan is reached and the
unit is not draining, the OF code will appear on the display. If this occurs in heating mode, check that the condensate
drain pipe is not bent or obstructed, thus preventing the water from fl owing out.
It is possible to empty the collection pan using the safety drain at the base of the unit if necessary.
1 Safety drain to empty pan
2 Condensation drain duct
To Next Page
Loading...
Need help?
General