Curve mount – Permanent 3M
TM
VHB
TM
adhesive labels adhere to the underside base of our
universal quick clip. Ideal for helmets of any size or material finish.
Surface Preparation for Curve Mount:
1. Use rubbing alcohol to clean the mounting surface.
2. Wipe dry the surface.
3. Remove adhesive protective label.
4. Apply your mount to surface.
5. Press and hold for sixty seconds to allow adhesive to bond to the surface.
6. Bond strength will increase through time. At room temperature, wait for at least 24 hours
to achieve 90% bonding strength, and 72 hours for 100% bonding strength.
For more details, please visit 3M
TM
website, under 3M
TM
VHB
TM
tapes technical data section or follow
this link: http://solutions.3m.com/wps/portal/3M/en_US/VHB/Tapes/Document-Center/Technical-Data/
and down load PDF file: Surface Preparation for 3M™ VHB™ Tape Applications.
NOTE: To see how to properly install all mounts, please click on www.epicstealthcam.com/mountings.
To purchase additional mounts, go to www.epicstealthcam.com or call toll free: 877-269-8490
To Next Page
Loading...
