Epilog Laser Fusion Pro 32 User Manual

3. Lower the rear wheel casters until the rubber pad contacts the floor and raises the wheel o of the
floor. This will be the pivot point when the machine is tilted onto its back..
4. Open the main door on the machine and remove any table plaorms from the machine, such as
the Engraving Table, Vector Cutting Grid or Slat Table.
- 167 -
SECTION 10: SYSTEM MAINTENANCE

Epilog Laser Fusion Pro 32 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 32
Category	Engraver
Language	English