Epilog Laser Fusion Pro 32 User Manual

Machine Settings:
• Acceleration Match Oset [cnts]
● Number of encoder counts to delay firing laser when accelerating. Used for raster quality
adjustments
• Deceleration Match Oset [cnts]
● Number of encoder counts to delay firing laser when decelerating. Used for raster quality
adjustments
• Bed Margins [in]
● The margins around the bed, in inches that the carriage can travel to.
● Format is as follows: TOP,LEFT,BOTTOM,RIGHT
• Bed Size [in]
● The size of the bed in the machine in inches
● Format is as follows: WIDTH,HEIGHT
● Requires “Home Axis” to take eect
• Disable Table Homing
● Setting to disable homing the table when the machine boots. For optimal operation, leave this at
a value of 0
● A value of 1 will disable table homing
● Will take eect aer reboot
• Rotary Encoder [cnts/in]
● The number of encoder counts per inch of travel for the rotary device
● Requires “Home Axis” to take eect
• X Axis Encoder [cnts/in]
● The number of encoder counter per inch of travel for the X Axis
● Requires “Home Axis” to take eect
● Must recalibrate cameras if this changes
• Y Axis Encoder [cnts/in]
● The number of encoder counter per inch of travel for the Y Axis
● Requires “Home Axis” to take eect
● Must recalibrate cameras if this changes
• Home Oset [in]
● The oset of the table origin, relative to the X and Y limit switches
● Requires “Park Axis” to take eect
● Must recalibrate cameras if this changes
• Joystick Center X
● The center X position of the joystick, in joystick units
• Joystick Center Y
● The center Y position of the joystick, in joystick units
• Joystick Deadzone [%/100]
● The percentage of dead zone around the center of the joystick
• Joystick Limit X
● The MIN and MAX limits for the X axis of the joystick, in joystick units
- 228 -
APPENDIX C: SYSTEM CALIBRATION

Epilog Laser Fusion Pro 32 Specifications

General

Brand	Epilog Laser
Model	Fusion Pro 32
Category	Engraver
Language	English