- 73 -
SECTION 7: FUSION CONTROL PANEL
Display
27. Laser TI: This sets the Tickle of the laser tube. This setting is normally a factory only setting and will not need to be
adjusted by the user.
28. Pulse Stretch: This sets the Pulse Stretch of the laser tube. This setting is normally a factory only setting and will
not need to be adjusted by the user.
29. Table Speed Adj: This adjusts the speed of the table and is normally a factory only setting that should not be
adjusted by the user.
30. Bed Size: This indicates the bed size. This setting is normally a factory only setting and will not need to be adjusted
by the user.
31. System Unit: Sets the units of the machine to inches or millimeters.
32. Fiber Laser Power: This the wattage of the fiber laser source and should not be changed by the user.
33.
♦ Full Table Home: This setting resets all temporary Home Positions and reestablishes the default Home Position
that is found at boot up.
34. Raster Tune Adj: This fine tunes raster engraving mode and is normally a factory only setting that should not be
adjusted by the user.
35. Vector Tune Adj: This fine tunes the vector cutting mode and is normally a factory only setting that should not be
adjusted by the user.
36. Calibrate Joystick: This setting is normally a factory only setting. It reestablishes the feel of the Joystick.
37. Rotary Installed: This displays if a Rotary Attachment is currently installed.
38. Rotary Version: This displays the Rotary version that is installed.
39. Y Drive Version: This displays the Y Drive version that is installed.
40. X Drive Version: This displays the X Drive version that is installed.
41. Passcode: The passcode feature on the Fusion laser allows you to create a passcode to lock the factory set
machine functions within the Settings menu so they cannot be changed accidentally.
To Establish a Passcode:
• Go to the Settings menu on the Fusion Keypad and tilt the Joystick up until you see Passcode 0000.
• Center click the Joystick to gain access and show the cursor.
• Tilt the Joystick up or down to increment or decrement the first number. Tilt the Joystick left or right to
increment or decrement the next number. Continue the process until you have set a four-digit Passcode
number.
• Write down your Passcode and save it in a secure place!
• Press the Go key to exit and display your Passcode.
• To finalize the lock process, tilt the Joystick down while still in the Settings menu until you see the Lock
Config menu item.
To Next Page
