U Page 22
Digital controller RK 4004
42 = Expanded setup-mode
In setup mode all existing parameters may be selected and the
parameter values viewed. Some of the parameter values may
be changed immediately. The protected parameters may only
be changed once value 42 has been entered. This entry furnis-
hes access to what is known as "expanded setup-mode". In ex-
panded setup mode all parameters that can be changed, may
be changed.
44 = Save customer settings
In this form of saving all parameter settings are stored in a
backup list. If necessary, all customer-specific settings may be
reloaded using parameter "..2. reset settings" .
98 = Delete error memory
This command should only be used by E+L service personnel.
The controller card can store up to 100 errors that have occur-
red. If the number of errors exceeds the 100 mark, the error
messages are pushed out at the back of the error memory and
are thus deleted.
99 = Delete data memory
This command should be used by E+L service personnel. The
entire data memory of the controller card is deleted. Once the
controller card is switched on the default values are automati-
cally loaded.
No commands are performed until a parameter change has
been executed!
To Next Page
Loading...
Need help?
General