Centrifuge 5804/5804 R and 5810/5810 R
3 Error lists / Troubleshooting
3-32 Error lists/Troubleshooting
valid for centrifuges with software from version 3.0 onwards
The load cycles are recorded separately for each rotor type.
START Program 14
xxx – no. of starts
START – next display
xxxx – no. of runs completely
Key PROG –erases the number
START – next display
yy – rotor number CL
xxxx – no. of load cycles per rotor type
START – next rotor number CL
Key PROG –erases the number n for this rotor only
Cursor keys–change the number of load cycles in steps of 500
START – next display
xxxx – no. of operating hours
START – end of program
EA xxxx
CL xxxxxx
CLyy xxxxxx
h xxxxx
MSTM/0408
To Next Page
Loading...
