Eppendorf 5804 - EEPROM Value Viewing

Error lists/Troubleshooting 3-33
Centrifuge 5804/5804 R and 5810/5810 R
3 Error lists / Troubleshooting
Viewing the values stored in the EEPROM (for factory checks)
START program 15
yy – rotor number
xxx – switching-off values for all rotors (no. 2, 3, 4, 5, 8, 13, 14, 17, 18)
always continue switching with START
START
xxx – idle value imbalance sensor (measurement during the imbalance calibration)
Start
xxx – max. imbalance value for 30g-run G3 with rotor A-4-81 (from software 3.4 onwards)
Start
xx – rotor number calibration rotor fixed-angle rotor
Start
xx – rotor number calibration rotor swing-bucket rotor
Start
xx – idle value position sensor locking mechanism for lid
Start
xxx – voltage version
Uyy xxx
Ur xxx
U3 xx x
RW x x
RA x x
DV x x
SP x x x
MSTM/0408