Eppendorf Mastercycler Gradient - Options Menu: System Settings; Editor Options and Display Settings

12
5 Description of menus
5.4 OPTIONS
The "OPTIONS" menu can be used to define general system settings for the program editor, printer,
time/date, etc.
Selection of YES/NO, ON/OFF and other settings can be carried out using the key.
The menu is exited by pressing the key.
5.4.1 Editor
Show Ext. Steps To display temperature options.
YES All options (temperature increment, time increment, ramp, ramp increment, gradient) for
each step appear in the display.
NO Only the nominal temperature and the cycle time appear in the display. If the options
have been defined, the command is marked with an "
*
" for information purposes when
the program is called up. Nonetheless, the options can be called up by pressing the
key and can then be entered or displayed.
OPTIONS . .
Editor
Printer
Gradient
GENERAL . .
STANDARD
– –/25.0°
Main-Menu
Start
FILES . .
OPTIONS . .
Lid
Incubate
STANDARD
– –/25.0°
OPTIONS . .
Editor
Printer
Gradient
GENERAL . .
STANDARD
– –/22.0°
Editor Mode
Show Ext. Steps: YES