45
10 Interface description
10.1 Printer / PC connection
Printer connection
The printer connection socket (25 pins, Centronics parallel interface, PC compatible) is located below the
PC connection socket on the right-hand side of the device (see Sec. 4.1, Fig. 2.6).
Connect the Mastercycler
®
or Mastercycler
®
gradient and printer via a commercially available PC printer
cable. The cyclers and printer must be switched off during installation. If the printer is not used frequently,
the printer cable should be disconnected from the cycler port and only be installed when needed.
The parameters for the printer are set in the "OPTIONS/Printer" menu.
Print programming
Printout Editor: NO
Printing is switched off.
Printout Editor: YES
The program in the "Edit" menu is printed out.
Select "YES" using the key and confirm by pressing .
"Printout Editor: NO" is selected automatically after the printout.
Print program protocol
Print Protocol: OFF
The program sequence is not printed out.
Print Protocol: ON
The program sequence is printed out.
10 Interface description
To Next Page
Loading...