51
12 Troubleshooting
E
rr Link (1)
...
Line ..
LINK command cannot be executed.
Program not found.
Program name and program line of
defective LINK command appear in
the display.
Only programs from the internal
memory can be called up by the LINK
command. Programs on a personal
card and the program in the
processing level ("Edit") cannot be
called up by the LINK command.
E
rr Link (2)
...
Line ..
Too many programs are connected
by LINK commands.
Program name and program line of
defective LINK command appear in
the display.
A maximum of five programs, i.e. four
LINK commands, can be processed
in succession.
E
rr No Program No executable program available in
memory.
Load program from memory or
personal card, or define a program
in "Edit" menu and restart.
F
AN ERROR! Defective internal fan. Switch off device.
Contact SERVICE.
F
AT Full Number of programs which can be
administrated has been exceeded.
Internal memory: 99 programs
personal card: 10 programs
Delete programs which are not
required.
I
nternal EE-Err Technical defect. Contact SERVICE.
L
EFT BLOCK
DEFEKTIV!
Defective regulator or electronics
on left-hand block.
Switch off device.
Contact SERVICE.
L
ID TOO HOT! Defective electronics. Contact SERVICE.
L
ink not found Program branching is not possible
because the program which was
supposed to be called up has been
deleted.
Check the LINK command.
Enter the missing program.
L
ink Error Program branching is not possible
because the program which was
supposed to be called up has been
deleted.
Check the LINK command.
Enter the missing program.
M
Card Error The memory of the personal card
is defective.
Evaluate further messages.
M
emory corrupted The internal memory is defective. The internal memory must be
deleted.
This deletes all programs.
Error message Cause Solution
To Next Page
Loading...