7) Move cartridge carriage to the left, then slide dampers and tubes under bar (shown below)
8) Pull ink from bottles to fill tubes. To do this, squeeze the suction bottle and insert the tip of the bottle
into the bottom hole of a damper. Press the tip of the bottle tightly into the damper hole to get a good
seal then release the bottle so it pulls ink from the bottle thru the tube and to the damper.
9) Close ink tube clamp. For best flow, fill the damper channel and oval chamber with ink as much as
possible, but it is unnecessary to draw ink into the suction bottle. Once ink fills the damper, clamp the
ink line closed (shown below).
11/5/09 © Vermont PhotoInkjet Page 3 of 6
To Next Page
Loading...
