EasyManua.ls Logo

Epson BrightLink 475Wi - Replacing the Pen Batteries

Epson BrightLink 475Wi
259 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
4. Close the battery cover and press it down until it clicks into place.
Warning: Dispose of used batteries according to local regulations. Do not expose batteries to heat
or flame. Keep batteries out of the reach of children; they are choking hazards and are very
dangerous if swallowed.
Parent topic: Projector Maintenance
Related references
Remote Control Operation
Replacing the Pen Batteries
Each pen uses one AA alkaline or Sanyo Eneloop rechargeable battery. Replace the battery as soon as
it runs out.
When the battery is low, the pen light flashes as you turn on the switch. When the battery runs out, the
pen light goes out.
Caution: Use only the type of batteries specified in this manual.
1. Open the battery cover as shown.
182

Table of Contents

Other manuals for Epson BrightLink 475Wi

Related product manuals