47
English
K Turn off the display of the test pattern
Press the [Esc] button on the remote control or control panel to turn off the test pattern.
7 Attaching the Covers
A Attach the wall plate cover and end cap
If you need to use a security cable, make sure you attach it before installing the wall plate cover. See
page 66 for instructions.
1. Attach the wall plate cover ( ). Snap the tabs on the cover into the holes on the wall plate. (If you
need to remove the cover, press the tabs.)
2. Place the end cap with the concave portion facing up ( ).
You can use the wall plate cover extender (if included) to increase the depth of the wall
plate cover and accommodate larger cables and plugs.
To add the extender, clip each half of the extender to the wall plate cover pieces before
you attach the cover to the mount.
Adding the wall plate cover extender limits the minimum size of the projected image.
See page 20 for more information.
Depending on how the cables are wired, you may need to cut out parts of the wall
plate cover to allow the cables to be passed through it.
When cutting the thin section of the wall plate cover and passing the cables through,
make sure you perform deburring to smooth off any sharp edges to prevent damaging
the cables.
Also, make sure you operate the cutter safely.
Tighten all screws firmly. Otherwise, the projector or wall mount may fall and cause personal
injury or property damage.
Warning
End cap
Wall plate cover
To Next Page
Loading...
