51
English
2. Slide the dial cover down to remove it.
3. Remove the two markers from inside the Touch Unit.
Use the markers to perform the angle adjustment (p. 53) after installing the Touch Unit.
D Determine the installation position for the Touch Unit
Mark the following installation positions:
• ( ): The center line of the installation pattern; align it with the center line of the Touch Unit ( ).
• ( ): 1 inch (25 mm) from the top edge of the projected image; align with the bottom edge of the
Touch Unit.
The Touch Unit must be installed above the image area.
1.0 in. (25 mm)
To Next Page
Loading...
