13
© 2016 IVS Computer Technology®, Inc. All rights reserved
Projector has overheated and turned off. Leave
it turned off to cool down. After about five
minutes, do the following:
Make sure the vents and air filter are not
clogged with dust or obstructed by
nearby objects.
Clean or replace air filter.
If operating the projector at high altitude,
turn on the High Altitude Mode
If the problem persists, unplug the
projector and contact Epson.
The lamp has a problem.
Check to see if the lamp is burned out,
broken, or installed incorrectly. Reinstall
or replace the lamp if necessary.
Clean or replace air filter.
If operating the projector at high altitude,
turn on the High Altitude Mode
If the problem persists, unplug the
projector and contact Epson.
Replace the lamp soon to avoid damage. Do not
continue using the projector.
A fan or sensor has a problem. Turn off the
projector, unplug it, and contact Epson.
Auto Iris error. Turn off the projector, unplug it,
and contact Epson.
Power error (ballast). Turn off the projector,
unplug it, and contact Epson.
Internal projector error. Turn off the projector,
unplug it, and contact Epson.
To Next Page
Loading...
