1.4.4 Error Conditions
The printer can detect various errors and indicate them with LEDs. Refer to Table 1-14.
1.4.5 Printer Initialization
There are three initialization methods: power-on initialization, software initialization and operator
initialization.
1.4.5.1 Power-On Initialization
This initialization of this level is activated by power-on or cold-reset command(remote RS command).
This initialization is:
-to initialize the printer mechanism.
-to execute Operator initialization.
1.4.5.2 Software Initialization
This initialization of this level is activated by the control code ESC @. This initialization is:
- -to clear the unprinted data.
- -to make the printer’s setting defaults.
1.4.5.3 Operator Initialization
The initialization of this level is activated by-INIT signal (negative pulse), reset operation through
panel or head replacement between monchrome and color.
- - to clear all data in the print buffer
- to cancel the download character definition.
- to make the printer stand-by state, if no errors occur.
- to execute Software initialization.
Product Description Epson Stylus Color 200 /Epson Stylus 200
1-16 Rev. A
To Next Page
Loading...
