Projector Indicator Status
104
The indicators on the projector indicate the projector status and let you know
when a problem occurs. Check the status and color of the indicators and then
refer to this table for a solution.
a
If the indicators display a pattern not listed in the table below, turn the
projector off, unplug it, and contact Epson for help.
A
Status indicator
Projector status
Indicator status Problem and solutions
Lit blue Normal operation.
Flashing blue Warming up, shutting down, or cooling down.
When warming up, wait about 30 seconds for an image
to appear.
Remote control operations may be disabled when the
indicator is flashing blue.
Indicator status Problem and solutions
Off Projector is in standby status.
When you press the power button, projection starts.
Lit orange Projector has overheated and turned off. Leave it turned
off to cool down for 5 minutes.
• Make sure that the air vents are not clogged with dust
or obstructed by nearby objects.
• Make sure the environmental temperature is not too
hot.
• If the problem persists, unplug the projector and
contact Epson for help.
Low air flow through the air filter.
• Make sure that the air vents are not clogged with dust
or obstructed by nearby objects.
• Make sure the environmental temperature is not too
hot.
• If the problem persists, unplug the projector and
contact Epson for help.
Low air flow through the projector.
• Make sure that the air vents are not clogged with dust
or obstructed by nearby objects.
• Make sure the environmental temperature is not too
hot.
• If the problem persists, unplug the projector and
contact Epson for help.
Flashing orange Lamp has a problem.
Turn the projector off, unplug it, and contact Epson for
help.
A fan or sensor has a problem.
Turn the projector off, unplug it, and contact Epson for
help.
Internal projector error.
Turn the projector off, unplug it, and contact Epson for
help.
To Next Page
Loading...
Need help?
General
