1.
Set the feed selector to
(Normal Feed).
2.
Extend the input tray extension. Pull out the output tray and output tray extension, and then raise the stopper.
Note:
If any thick originals are contained, store the output tray and do not use it. Let the ejected originals to stack directly onto
the table where the scanner is placed.
is
prevents the originals from bumping into the output tray and falling down.
3.
While holding the tab, slide the edge guides all the way out.
Placing Originals
>
Placing a Mixture of Originals at Dierent Sizes
64
To Next Page
Loading...
Need help?
General
