Epson DS-870 - Page 52

3. Load the originals at the center of the input tray in descending order of paper size with the widest at the back
and the narrowest at the front.
c
Important:
Check the following points when setting dierent sizes of originals.
❏ Slide the originals with their leading edges aligned, until they meet resistance in the ADF.
❏ Set the originals at the center of the input tray. Refer to the
u mark on the scanner as your guide.
❏ Set the originals straight.
If not, originals may be fed askew or jammed.
Note:
Load the originals into the input tray facing down and slightly displace the top edges at an angle facing into the ADF.
4. Slide the edge guides to
t
the edges of the widest original.
User's Guide
Specications of Originals and Placing Originals
52