Installation Guide
94
e
Select Installing the Touch Unit without the bracket
The following screen is displayed.
The next procedures are the same as for adjusting the angle (after step 11) when installing outside the
whiteboard using the bracket.
s
"Angle Adjustment" p.69
c
•
When installing the Touch Unit using magnets, stick labels on the tabs on the sides of the Touch
Unit. Match the center of the labels with the tabs.
•
If the Touch Unit moves out of position, use the labels to reinstall it at the correct position.
When you have finished making adjustments, perform a touch calibration.
s
"Touch Calibration" p.84
To Next Page
Loading...
