Others menu
Submenu Function
SNMP
Set to On to monitor the projector using SNMP.
To monitor the projector, you need to install the SNMP manager
program on your computer. SNMP should be managed by a
network administrator.
The default value is Off.
Trap IP Address
1/Trap IP Ad‐
dress 2
You can register up to two IP addresses for the SNMP trap
notification destination. You can enter a number from 0 to 255 in
each field of the address. However, the following IP addresses
cannot be used. 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x
is a number from 0 to 255)
AMX Device Dis‐
covery
When the projector is connected to a network, set this to On
when you want to enable the projector to be detected by
AMX
Device Discovery
g
. Set this to Off if you are not connected to an
environment controlled by a controller from AMX or AMX
Device Discovery.
Submenu Function
RoomView
Set this to On only when monitoring or controlling the projector
over the network using Crestron RoomView
®
. Otherwise, set
this to Off.
s "About Crestron RoomView
®
(EB-1880 only)" p.69
When this is set to On, the following functions are not available.
• Web control
• Message Broadcasting (EasyMP Monitor Plug-in)
Bonjour
Set this to On when connecting to the network using Bonjour.
See Apple's Web site for more information on the Bonjour
service.
http://www.apple.com/
List of Functions
87
To Next Page
Loading...
Need help?
Display
Power
Projection Lens
Weight and Dimensions
