Info Menu (Display Only)
Lets you check the status of the image signals being projected and the status of the projector. Items that can be displayed vary depending on the image signal
and Source currently being projected as shown in the following screen shots. Depending on the model used, some input sources are not supported.
s p.21
Computer Signal/Component Video
g
/USB/USB
Display
Composite video
g
/S-Video
g
LAN
Sub-menu Function
Lamp Hours
You can display the cumulative lamp operating time
*
.
When it reaches the lamp warning time, the characters are displayed in yellow.
Source
You can display the Source name for the connected equipment currently being projected.
Input Signal
You can display the settings of Input Signal in the Signal menu depending on the Source.
Resolution
You can display the resolution.
Video Signal
You can display the settings of Video Signal in the Signal menu.
Refresh Rate
g
You can display the refresh rate.
Sync Info
You can display the image signal Information.
It may be needed if service is required.
Status
This information is about errors that have occurred with the projector.
It may be needed if service is required.
Serial Number
Displays the projector's serial number.
* The cumulative use time is displayed as "0H" for the first 10 hours. 10 hours and above is displayed in 1 hour steps as "10H", "11H", and so on.
List of Functions
90
To Next Page
Loading...
Need help?
General
Weight and Dimensions
