Projector Indicator Status
75
The indicators on the projector indicate the projector status and let you know
when a problem occurs. Check the status and color of the indicators and then
refer to this table for a solution.
a
• If the indicators display a pattern not listed in the table below, turn
the projector off, unplug it, and contact Epson for help.
A
On/Standby (power) indicator
B
Status indicator
C
Laser indicator
D
Temp (temperature) indicator
Projector status
Indicator and status Problem and solutions
Power: Lit blue
Status: Lit blue
Laser: Off
Temp: Off
Normal operation.
Power: Lit blue
Status: Flashing blue
Laser: Off
Temp: Off
Warming up or shutting down. When warming up, wait
about 30 seconds for an image to appear.
All buttons are disabled during warm-up and shutting
down.
Power: Lit blue
Status: Off
Laser: Off
Temp: Off
Standby or sleep mode.
When you press the power button, projection starts.
Power: Flashing blue
Status: Off
Laser: Off
Temp: Off
Preparing to enter USB Power in Standby mode.
Power: Lit blue
Status: Flashing blue
Laser: Off
Temp: Off
Cooling down; all buttons are disabled.
Power: Flashing blue
Status: Indicator status
varies
Laser: Indicator status
varies
Temp: Flashing orange
Projector is too hot.
• Make sure that the vents and air filter are not clogged
with dust or obstructed by nearby objects.
• Clean or replace the air filter.
• Make sure the environmental temperature is not too
hot.
To Next Page
Loading...
Need help?
General
