Epson EB-X04 User Manual

132
Replacing the Remote Control Batteries
The remote control uses two AA manganese or alkaline batteries. Replace the
batteries as soon as they run out.
Warning
Check the positions of the (+) and (–) marks inside the battery holder to
ensure the batteries are inserted the correct way. If the batteries are not used
Attention
correctly, they could explode or leak causing a fire, injury, or damage to the
Make sure you read the Safety Instructions before handling the batteries.
product.
a
Open the battery cover as shown.
d
Close the battery cover and press it down until it clicks into place.
b
Remove the old batteries.
c
Insert the batteries with the + and – ends facing as shown.

Epson EB-X04 Specifications

General

Projection System	3LCD
Resolution	XGA (1024 x 768)
Contrast Ratio	15, 000:1
Lamp Type	200W UHE
Zoom	1.2x
Projection Lens Focal Length	16.9 - 20.28 mm
Projection Lens Focus	Manual
Weight	2.4 kg
Projection Size	30 - 300 inches
Lamp Life	10, 000 hours (ECO mode)
Keystone Correction	Vertical ±30 degrees
Projection Ratio	1.48 - 1.77:1
Interfaces	HDMI, VGA, USB Type-A, USB Type-B
Security	Kensington lock
Colour Modes	Dynamic, Presentation, Cinema, sRGB
Power Consumption	270W (Normal)
Noise Level	37 dB (Normal)
LCD Panel	0.55-inch with MLA (Micro Lens Array)