74
Color Difference Correction when Projecting from Multiple Projectors
a
Aim the remote control at the target projector and press the [ID]
b
While holding the [ID] button, press the number button that matches
button. the ID of the projector you want to operate.
The current Projector ID is displayed on the projected screen. It
disappears after about 3 seconds.
The projector you want to operate is selected.
c
Press the [ID] button to check if the ID-setting process worked.
You see a message displayed by the projector.
• If the remote control is listed as On, you can operate the projector
from the remote control.
• If the remote control is listed as Off, you cannot operate the projector
from the remote control. Repeat the steps above to enable the remote
control.
• You must select the projector ID from the remote control each
time you turn on the projector you have set it to control. When
a
you turn on the projector, 0 is selected as the remote control's
projector ID.
• When you set the Projector ID setting to Off, you can operate
the projector using the remote control whichever ID you select
on the remote control.
• When you select 0 on the remote control, you can operate all
projectors regardless the Projector ID setting.
To Next Page
Loading...
Need help?
General
