Submenu Function
SSID Auto Set
ting
(This can only be set if Connection Mode is set to Quick.)
When you set this to On, you can search for the projector more
quickly from among multiple projectors. SSID is set
automatically.
When connecting to multiple projectors from one computer in
Quick mode, set this to Off, and set the same SSID in all the
projectors that will connect.
SSID
(This item can only be set when SSID Auto Setting is set to
Off.)
Enter an
SSID
g
. When an SSID is provided for the wireless LAN
system in which the projector participates, enter the SSID.
You can enter up to 32 single-byte alphanumeric characters ( ^
can only be entered from the Web browser). If the SSID is left
blank or set to ANY, an ANY connection (selects a connection
from local access points without specifying an SSID) is
established.
Search Access
Point
(This item can be set only if Wireless Mode is set to Wireless
LAN On, and Connection Mode is set to Advanced.)
The projector searches for a local access point. This allows you to
perform wireless LAN setup by simply selecting the connection
location of the wireless LAN.
Submenu Function
IP Settings
(This item can only be set if Connection Mode is set to
Advanced.)
You can make network settings.
DHCP: Set to On to make network settings using
DHCP
g
. If this
is set to On, you cannot set any more addresses.
IP Address: You can input the
IP address
g
assigned to the
projector. You can enter a number from 0 to 255 in each field of
the address. However, the following IP addresses cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
Subnet Mask: You can input the
subnet mask
g
for the projector.
You can enter a number from 0 to 255 in each field of the address.
However, the following subnet masks cannot be used.
0.0.0.0, 255.255.255.255
Gateway Address: You can input the IP address for the gateway
for the projector. You can enter a number from 0 to 255 in each
field of the address. However, the following
Gateway addresses
g
cannot be used.
0.0.0.0, 127.x.x.x, 224.0.0.0 to 255.255.255.255 (where x is a
number from 0 to 255)
SSID Display
To prevent the
SSID
g
from being displayed on the LAN Standby
screen, set this to Off.
IP Address Dis
play
To prevent the
IP address
g
from being displayed on the LAN
Standby screen, set this to Off.
List of Functions
112
To Next Page
Loading...
Need help?
General
