When writing completes normally, the projector enters standby
status.
Power: Blue - On
When the projector is in standby status, remove the USB storage
device.
Reflecting saved settings to other projectors
a
Disconnect the power cord from the projector, and check that all
of the projector's indicators have turned off.
b
Connect the USB storage device containing the saved batch setup
file to the projector's USB-A port.
a
• When the USB storage device contains 1 to 3 types of batch
setup files, the file is reflected to the projector with the same
model number. If there are multiple files for a projector with
the same model number, the settings may not be reflected
correctly.
• When there are four or more types of batch setup files on the
USB storage device, the settings may not be reflected
correctly.
• Do not store any data except for the batch setup file on the
USB storage device. If the USB storage device contains data
other than the batch setup file, the settings may not be
reflected correctly.
Performing Batch Setup for Multiple Projectors
122
To Next Page
Loading...
Need help?
General
