a
• Connect the USB storage device directly to the projector. If
the USB storage device is connected to the projector through
a USB hub, the settings may not be saved correctly.
• Connect an empty USB storage device. If the USB storage
device contains data other than the batch setup file, the
settings may not be saved correctly.
• If you have saved a batch setup file from another projector to
the USB storage device, delete the file or change the file
name. The batch setup function cannot overwrite a batch
setup file.
• The file name for the batch setup file is PJCONFDATA.bin. If
you need to change the file name, add text after
PJCONFDATA. If you change the file name in any other way,
the projector may not be able to recognize the file correctly.
• You can only use single-byte characters for the file name.
c
While holding down the [Esc] button, connect the power cord to
the projector.
When the projector's indicators turn on as follows, release the [Esc]
button.
Power: Blue - On/Status: Blue - On/Lamp: Orange - On/Temp: Orange - On
When all of the indicators start flashing, the batch setup file is being
written.
Caution
• Do not disconnect the power cord from the projector while the file is
being written. If the power cord is disconnected, the projector may not
start correctly.
• Do not disconnect the USB storage device from the projector while the
file is being written. If the USB storage device is disconnected, the
projector may not start correctly.
Performing Batch Setup for Multiple Projectors
121
To Next Page
Loading...
Need help?
General
