Epson EH-TW6000 User Manual

Basic Operations
23
If the Target Image is not Projected
If the image is not projected, you can change the source using one of the following methods.
Remote control Control panel
Press the button for the target port.
Press the
button and select the target port.
Press the
button to confirm the selection.
c
•
For video equipment, start playback first and then change the source.
•
If the projector is suspended from a ceiling, after removing the lens cap, make sure you keep it in a safe
place as you will need to attach it when transporting the projector.
•
If the color looks unnatural when changing to a Video or Component source, check that the port you
have connected to is the same as the Input Signal.
s Extended - Input Signal - Video Signal/
Component p.63
Turning off the Power
a
Turn off the connected equipment.
b
Press the button on the remote
control or the projector's control
panel.
Remote control Control panel
A confirmation message is displayed.
c
Press the button again.
c
When Standby Confirmation is
set to Off, you can turn off the
projector by pressing the
button on the remote control
once.
s Extended - Display -
Standby Confirmation p.63
d
Wait until cool-down is complete.
The operation indicator on the projector's
control panel stops flashing.
e
Disconnect the power cable.
c
If the power cable is connected,
some electricity is consumed even
if no operations are made.

Epson EH-TW6000 Specifications

General

Matrix size	0.61 \
Projection distance	2.95 - 4.8 m
Projection technology	LCD
Contrast ratio (typical)	-
Screen size compatibility	- \
Projector native resolution	1080p (1920x1080)
Keystone correction, horizontal	± 30 °
Aspect ratio	16:9
RS-232 ports	1
Connectivity technology	Wired
Focal length range	18.2 - 29.2 mm
Aperture range (F-F)	1.51 - 1.99
Lamp type	UHE
Lamp power	230 W
Light source type	Lamp
Service life of light source	5000 h
DVI port	No
AC (power) in	Yes
USB connector type	USB Type-A
Serial interface type	RS-232
USB 2.0 ports quantity	USB 2.0 ports have a data transmission speed of 480 Mbps, and are backwards compatible with USB 1.1 ports. You can connect all kinds of peripheral devices to them.
S-Video inputs quantity	0
Supported video modes	1080p
Supported graphics resolutions	1920 x 1080 (HD 1080)
RMS rated power	20 W
Product color	Black
Market positioning	Home cinema
Power source	AC
AC input voltage	100 - 240 V
Voltage tolerance	10 %
AC input frequency	50 - 60 Hz
Power consumption (standby)	- W
Power consumption (typical)	274 W
Noise level	- dB
Noise level (economic mode)	24 dB

Weight and Dimensions

Weight	6000 g