Basic Operations
28
Adjusting the Volume
You can adjust the volume by using the buttons on the remote control or the buttons on
the projector's control panel.
Remote control Control panel
c
•
You can also adjust the volume from the configuration menu. s Settings - Audio p.61
•
Under normal conditions, you can adjust the volume of the projector's built-in speaker. However, by
connecting an AV system to the projector and setting HDMI Link to On and Audio Out Device to AV
System, you can adjust the AV system's volume when projecting from HDMI1, HDMI2, and
WirelessHD sources.
s p.49
Caution
Do not start at high volume.
A sudden excessive volume may cause loss of hearing. Always lower the volume before powering off, so
that you can gradually increase the volume when you next turn on the power.
Hiding the Image and Sound Temporarily (A/V Mute)
You can use this to temporarily hide the image on the screen.
Each time you press the
button, A/V Mute turns on or off.
c
If you use this function when projecting moving images, the images and sound continue to be played
back by the source, and you cannot return to the point where A/V Mute was activated.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
