Useful Functions
42
Projecting 3D images
a
Connect an AV device capable of
playing 3D images to the projector.
b
Turn on the AV device and the
projector, and then press the
button.
If the 3D image is projected automatically,
you do not need to press any buttons.
c
•
How a 3D image is perceived varies depending on the individual.
•
The image is not displayed in 3D if 3D Display is set to Off. Press the button on the remote
control.
s Signal - 3D Setup - 3D Display p.58
•
The projector automatically selects the appropriate 3D format, but if the 3D image is not displayed
correctly, use 3D Format to select another format.
s Signal - 3D Setup - 3D Format p.58
•
If the 3D effect is not displayed correctly, try reversing using Inverse 3D Glasses. s Signal - 3D
Setup - Inverse 3D Glasses p.58
•
When using the optional External 3D IR emitter, connect the cable to the rear of the projector, and
then set 3D IR Emitter to External.
s Signal - 3D Setup - 3D IR Emitter p.58
•
When a 3D image is displayed, a warning about viewing 3D images is displayed. You can turn off this
warning by setting 3D Viewing Notice to Off.
s Signal - 3D Setup - 3D Viewing Notice p.58
•
During 3D projection, the following configuration menu functions cannot be changed.
Aspect (set to Normal), Noise Reduction (set to Off), Sharpness, Split Screen, Overscan (set to Off)
•
How the 3D image is viewed may change depending on the temperature of the surroundings and how
long the lamp has been used. Refrain from using the projector if the image is not projected normally.
•
3D images may not be displayed correctly if they are being affected by other infrared communication
devices.
To Next Page
Loading...
Need help?
General
Weight and Dimensions
